SFA-SANIFLO SANISWIFT - User Manual

1
03.11
IND3
224
INSTALLATION AND MAINTENANCE INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION ET D’ENTRETIEN
The user should retain these instructions for future reference • A lire attentivement et à conserver à titre d’information
This product must be installed in strict accordance with local plumbing codes.
Product should be installed by a licensed plumber.
Le produit doit être installé dans le respect des règlements sanitaires locaux.
Le produit doit être installé par un plombier qualifié.
USA CDN
226692
9709 224 NOTICE SANISWIFT 032011.indd 19709 224 NOTICE SANISWIFT 032011.indd 1 29/03/11 16:3229/03/11 16:32

Summary

Installation

Side Inlets Connection

Instructions for connecting additional fixtures to the pump's side inlets.

Top Inlet Connection

Bathtub; Shower Installation

Discharge Connection

Details on connecting the discharge pipe, including material and slope requirements.

Ventilation System Connection

Instructions for connecting the pump's vent system using PVC or ABS pipe.

Power Supply Connection

Critical safety instructions for connecting the pump to a GFCI-protected power outlet.

Pump Usage Guidelines

Repair Guide

Common Problems and Solutions

Troubleshooting guide for common operational issues like slow drainage, motor problems, or no evacuation.

Advice

Discharge

Freezing

Electricity

Safety reminder to disconnect power and use a Ground Fault Circuit Interrupter.

Gravity Fall

No Diagonal Uphill Pipe Runs

Limited Warranty

Conditions

Requirements for the product to be covered by the warranty.

Part or Product Exchange

Limitations

SFA-SANIFLO SANISWIFT Specifications

General

Protection Rating	IP44
Motor Type	Induction
Power	400W
Max Head	5m
Outlet Diameter	3/4 inches
Discharge Pipe Diameter	3/4 inches
Maximum Vertical Pumping Distance	5m
Maximum Fluid Temperature	60°C
Power Consumption	400W