SFA Sanicompact C4 User Manual

1
09.13
IND1
212
®
CDN USA
The user should retain these instructions for future reference
A lire attentivement et à conserver à titre d’information
IMPORTANT
DO NOT RETURN ANY MERCHANDISE TO THE VENDOR
NE PAS RETOURNER DE MARCHANDISE AU VENDEUR
For customer Service, Returns or Technical Questions, please call Saniflo’s Technical support toll-free at
800-571-8191 (USA) or 800-363-5874 (CDN).
Pour le service client, les retours ou toute question technique, merci d’appeller le service technique de Saniflo
au numéro suivant : 800-571-8191 (USA) or 800-363-5874 (CDN).
INSTALLATION AND MAINTENANCE INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION ET D’ENTRETIEN
This product must be installed in strict accordance with local plumbing codes.
Product should be installed by a license plumber.
Le produit doit être installé dans le respect des règlements sanitaires locaux.
Le produit doit être installé par un plombier qualifié.

SFA Sanicompact C4 Specifications

General

Brand	SFA
Model	Sanicompact C4
Category	Toilets
Language	English

Summary

Important Product Information

Vendor Return Policy

Instructions not to return merchandise to the vendor for service or questions.

Technical Support Contact

Toll-free numbers for customer service, returns, and technical questions.

Installation Requirements

Must be installed according to local plumbing codes by a licensed plumber.

General Description and Operation

General Description

Product components overview, including toilet body and macerating/pump unit.

Normal Operating Cycle

Details on the electronic program's macerating and pumping functions.

List of Parts Supplied

Reference to figure n°2 for included parts.

Dimensions

Reference to figure n°3 for product dimensions.

Performance Curve and Technical Data

Specifications on vertical pumping, voltage, frequency, and power.

Installation Procedures

Attaching the Toilet to the Floor

Steps for securing the toilet bowl to the floor using screws and brackets.

Discharge Elbow Connection

Instructions for connecting the discharge elbow to the waste tube and sleeve.

Sink Installation

Procedure for connecting a sink drain to the SANICOMPACT unit.

Water Supply Connection

Requirements for connecting the unit to a 1/2-inch water supply.

Electrical Connection

Guidelines for connecting the unit to a 120V, 60Hz GFCI outlet.

Start-Up, Programming, and Usage

Initial Start-Up Procedure

Steps for plugging in, rinsing, and testing the unit after installation.

Flush Programming

How to adjust the eco flush length and exit programming mode.

Unit Usage and Maintenance

Maintenance, acceptable waste, and power failure precautions.

Returning a Defective Unit

Procedure for returning a defective unit, including cleaning and disinfection.

Motor Dismantling for Qualified Personnel

Steps for disconnecting electrical supply, water, and removing the motor.

Installation Advice and Best Practices

Pipe Supports and Bends

Recommendations for supporting pipework and using appropriate bends.

Vertical Installation and Pipe Runs

Guidelines for vertical lifts, horizontal runs, and avoiding uphill pipe slopes.

Access, Drainage, and Soil Stack Connection

Ensuring access, gravity fall, minimum pipe run, and soil stack connection.

Freezing Protection and Electrical Safety

Instructions for insulating pipework, winterizing, and electrical safety.

Limited Warranty Information

Warranty Conditions

Conditions for warranty coverage, including proper use and electrical connection.

Part or Product Exchange Procedure

Procedure for exchanging the product, requiring return authorization and proof of purchase.

Warranty Limitations and Exclusions

Exclusions from warranty, such as disconnection costs and consequential damages.