Contents
Safety / Warning ................................................2
Component Identification....................................3
Uncrating / Unpacking..........................................4
Initial Setup Requirements....................................4
Accessory Kit............................................................5
Laser Marking Machine Connections..................5
Driver Installation ................................................7
Software Setup (Ezcad) ..........................................9
Aligning the Emitter Head....................................9
Determining the Optimal Focal Point..................11
Use of the Included Foot Pedal..............................12
Technical Support................................................12
It is important that you read this guide PRIOR to uncrating and setting
up the machine. There may be slight differences in the appearance or
features of your machine depending on the model that you purchased.
Safety / Warning
It is important that you read this guide PRIOR to uncrating and setting
up the machine. There may be slight differences in the appearance or
features of your machine depending on the model that you purchased.
Laser safety glasses have been provided with your new machine. It
is extremely important that you observe all safety protocols when
operating the machine. Failure to do so can cause blindness or severe
personal injury.
-The working beam of the laser is INVISIBLE to the human eye
-ALWAYS wear Laser safety glasses when the laser is operating
-DO NOT place hands in the workspace when the laser is operating
-Both direct and indirect exposure to the beam can cause injury!
1 2
To Next Page
Loading...