9English
Primary
Directory
Secondary
Directory
Description
Color
Contrast Adjust the contrast of the image
Brightness Adjust the brightness of the screen
Color Temp Set up the color Temp. to be 9300K
6500K and 5500K.
OSD menu
Language Select the language you want
OSD H. Pos. Move the OSD left and right on the screen
OSD V. Pos. Move the OSD up and down on the
screen
OSD Timer Adjust OSD display time setting
Transparency Adjust OSD Transparency
Others
MODE Select PC GAME MOVIE display mode
Audio Volume N/A
Signal
Selection
Select DP signal or DVI signalor HDMI
Aspect Ratio Select the dispiay mode: 16:9 AUTO 4:3
DCR Mode Select the DCR Mode on or off (optional)
Reset
Restore to factory settings
Troubleshooting
Problem Solution
No Image on Screen 1. Check power button is switched to on.
2. Verify the brightness and contrast of the monitor.
3. If the power indicator is flashing, re-tighten the
signal cable.
4. If the signal indicator is notebook or laptop,
make sure that the signal has been switched to
screen mode.
Non-focus Image Check if the image signal cable is inserted properly
(upright position).
Flash Screen 1. The power is insufficient to connect the monitor
or too weak.
2. Remove speakers, fluorescence, lightings, AC
transformer, table fan and etc. from the monitor.
Wrong or Unusual
Colour
1. If red, green, blue, or any of the colour
disappears, check the signal cord is connected
properly.
2. Try connecting to another PC for comparison.
The Whole Screen
Appear Up and
Down H-rolling
Scan
1. Make sure that the input signal frequency is
within 55 – 76Hz.
2. Re-tighten the signal cable.
Operation
To Next Page
Loading...
General