Need help?Do you have a question about the SGS GPA520 and is the answer not in the manual?
Keep fuel away from all sources of ignition to prevent fire.
Stop use if engine speed changes uncontrollably, misfires, vibrates, smokes, or in bad weather.
Do not move while running; keep hands/feet clear of rotating parts.
Avoid touching hot engine or muffler parts.
Operate only in well-ventilated areas to avoid poisoning.
Initial 25:1 ratio, subsequent 40:1 ratio for fuel/oil mixture.
Fill tank carefully, leave 25mm gap, use correct fuel/oil mix.
Sequence for starting the engine using primer, choke, and recoil starter.
Procedure for cooling down and safely shutting off the engine.
Check moving parts, engine cleanliness, handles, and clean after use.
Inspect work area, keep bystanders away, check for underground obstacles.
Safely stop engine and auger to remove obstructions.
Inspect area, grip firmly, use throttle correctly, avoid forcing auger.
Monitor fuel, check fasteners, clean without pressure washers.
Steps for cleaning, drying, and refitting the air filter element.
Procedures for checking, cleaning, and replacing the fuel filter.
Tightening, checking gap (0.6-0.7mm), and inspecting for damage.
Using correct grease, checking, topping-up, and recommended change intervals.
Cleaning, draining fuel, internal oiling, and storing in a suitable environment.
Visual layout of all auger components with numerical references.
Detailed list of parts, their codes, and quantities.
Keep fuel away from all sources of ignition to prevent fire.
Stop use if engine speed changes uncontrollably, misfires, vibrates, smokes, or in bad weather.
Do not move while running; keep hands/feet clear of rotating parts.
Avoid touching hot engine or muffler parts.
Operate only in well-ventilated areas to avoid poisoning.
Initial 25:1 ratio, subsequent 40:1 ratio for fuel/oil mixture.
Fill tank carefully, leave 25mm gap, use correct fuel/oil mix.
Sequence for starting the engine using primer, choke, and recoil starter.
Procedure for cooling down and safely shutting off the engine.
Check moving parts, engine cleanliness, handles, and clean after use.
Inspect work area, keep bystanders away, check for underground obstacles.
Safely stop engine and auger to remove obstructions.
Inspect area, grip firmly, use throttle correctly, avoid forcing auger.
Monitor fuel, check fasteners, clean without pressure washers.
Steps for cleaning, drying, and refitting the air filter element.
Procedures for checking, cleaning, and replacing the fuel filter.
Tightening, checking gap (0.6-0.7mm), and inspecting for damage.
Using correct grease, checking, topping-up, and recommended change intervals.
Cleaning, draining fuel, internal oiling, and storing in a suitable environment.
Visual layout of all auger components with numerical references.
Detailed list of parts, their codes, and quantities.
To Next Page
General