What to do if excessive media is blown into the atmosphere by SGS Other?
If you notice excessive media being blown into the surrounding atmosphere when no vacuum extract is being used with your SGS Other, it's likely that the lid isn't secure. Make sure to secure the lid with the swivel clips, adjusting them as necessary.
What to do if there is moisture inside the SGS Other cabinet?
If you find moisture inside the cabinet of your SGS Other, check the airline to ensure it is free from moisture.
Why is the blasting action uneven in my SGS SSB100 Other?
If the blasting action of your SGS Other is uneven, it might be due to too much abrasive media in the cabinet. Remove the excessive media to resolve this issue.
What causes inadequate speed in SGS SSB100?
If you experience inadequate speed or inefficient blasting with your SGS Other, it could be that the abrasive media is worn. Try replacing the abrasive media.
What to do if the abrasive in SGS Other is damp?
If the abrasive in your SGS Other is damp, renew the abrasive or dry it thoroughly before use.
Why is there static electricity present in my SGS Other?
If you are experiencing static electricity with your SGS Other, it may be due to dry weather conditions. Try leaving the item to be cleaned on the grid.
How to increase the pressure on SGS Other?
If the pressure is too low on your SGS Other, increase the inlet pressure and ensure the control valve is fully open.
What to do if SGS Other has loose connections?
If you notice a loose airline or loose connections on your SGS Other, tighten the fittings and ensure the airline is secure.
What to do if the air vent filter is missing in SGS Other?
If the air vent filter is missing from your SGS Other, replace the filter or blank off the hole in the rear panel temporarily with masking tape.
Mandatory safety advisory to read and retain the manual for future use.
Details on tool model, type, voltage, and air requirements.
Essential safety advice, including personal protection and abrasive selection.
Instructions for attaching hoses, filters, and securing components.
Steps for powering on the unit and performing essential pre-operation checks.
Guidance on loading, setting pressure, blasting, and improving results.
Steps after blasting, including safety and spill management.
Step-by-step guide for safely replacing abrasive and air nozzles.
Checks for serviceable parts, filter security, and lid clamp integrity.
Detailed steps for safely replacing the cabinet's fluorescent light tube.
Guidance on diagnosing and resolving common operational problems.
To Next Page
General