shapertools.com 2322
Safety & Care Compliance
Symbol
V
A
Hz
min
n0
.../min
Name
Explanation
Safety Alert
Read Operators
Manual
Indicates a potential
personal injury hazard
To reduce the risk of injury,
the user must read and
understand the operator’s
manual before using this
product.
Volts
Amperes
Hertz
Minutes
Alternating Current
No Load Speed
Per Minute
Voltage
Electrical Current
Frequency
(cycles per second)
Time
Type of current
Rotational speed at no load
Revolutions, strokes, surface
speed, orbits etc., per minute
Noise and Vibration Information
The typical values determined in accordance with
EN 60745 are:
Sound-pressure level 77dB
Sound-power level 88dB
Measuring uncertainty allowance K = 3dB
Overall vibration levels (vector sum for three
directions) are measured in accordance with EN
60745:
Vibration emission level (3-axis) a
h
< 2,5m/s
2
Uncertainty K = 1,5m/s
2
The specified emissions values (vibration, noise):
• Are used to compare machines.
• Are used for making preliminary estimates
regarding vibration and noise loads during
operation.
• Represent the primary applications of the
power tool.
An increase of these values is possible for other
applications, with different cutting bits, or if the
tool is not maintained. Take note of idling and
downtimes.
Equivalent Isotropic Radiated Power
The maximum RF output power is declared as
follows, in accordance with EN 300 328:
Maximum Conducted Power 16.4dBm
Maximum Antenna Gain 2dBi
Equivalent Isotropic Radiated Power 18.4dBm
Class II Equipment
Double-insulated construction
To Next Page
Loading...
