EasyManua.ls Logo

Shark CORDLESS V1900W - User Manual

Default Icon
14 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Copyright © EURO-PRO OPERATING LLC 2007
Cordless Sweeper
Barredora Electrónica
Model/Modelo: V1900W
7.2 Volt DC – 7,2 Voltios CC
IMPORTANT
IMPORTANT
To Maximize the life of your NiCd batteries:
1. Charge for a minimum of 20 hours before initial use.
Failure to do so will reduce the product’s battery life
significantly.
2. Do not store unit with the charging adapter attached
and plugged in.
3. Only recharge when the batteries are fully discharged
(or as close to fully discharged as possible).
4. Do not store in areas of high temperature or humidity.
5. After 3 months of non-use, the product should be fully
discharged and then recharged to maximize battery
power.
6. Use only the charger supplied with the product. If other
chargers are used, the batteries can fail causing damage to
the battery, product, or personal property.
NiCd batteries have a long useful life but at some time they
will need to be replaced. To purchase replacement batteries,
visit www.sharkvac.com
Note: 1. The On/Off switch must be in the “Off” position in
order to charge the unit. If the charging indicator
does not light, depress the On/Off switch once.
2. If the product has never been used or has been
stored for an extended period of time without use – it
will take several complete charge and discharge
cycles to realize the full operational time of your
product.

Table of Contents

Questions and Answers

  • S
    sellersmonicaAug 11, 2025
    What to do if my Shark CORDLESS V1900W sweeper will not operate?
    • K
      Kelsey TurnerAug 11, 2025
      If your Shark CORDLESS Blower sweeper isn't working, here's what you can check: * Make sure the batteries are charged. * Verify the electrical outlet for the charging adapter is working; check the fuse or breaker and replace or reset if needed. * Ensure the wire terminal connectors are securely attached. * Clear any obstructions from the rotating brush, then turn the unit off for 10 seconds before restarting.
  • M
    Melissa BeltranAug 17, 2025
    Why is my Shark CORDLESS Blower sweeper not picking up?
    • M
      Michelle RileyAug 17, 2025
      If your Shark CORDLESS Blower sweeper isn't picking up debris, the dust container might be full. Empty the dust container. Also, the unit may need recharging, so ensure it is fully charged.
  • A
    alexanderstewartAug 25, 2025
    What to do if my Shark CORDLESS V1900W Blower sweeper will not charge?
    • B
      Brian GillAug 25, 2025
      If your Shark CORDLESS Blower sweeper isn't charging, check the following: 1. Ensure the electrical outlet is working by plugging in another appliance. 2. Consider replacing the charging adapter. 3. Make sure the unit is in the “Off” position.
  • D
    Daniel GonzalezAug 29, 2025
    What to do if dust is escaping from my Shark CORDLESS V1900W Blower sweeper?
    • T
      Travis DiazAug 29, 2025
      If dust is escaping from your Shark CORDLESS Blower sweeper, the dust container is likely full. Empty the dust container.
  • C
    Cory AndersonSep 4, 2025
    How to fix a Shark CORDLESS V1900W Blower rotating brush that will not pick up?
    • K
      Kristy DeanSep 4, 2025
      If the rotating brush on your Shark CORDLESS Blower isn't picking up, the unit might be clogged. Check for excessive material on the brush or in the bottom of the sweeper and remove any obstructions from the brushes and/or sweeper. Also, the dust container may be full; empty and clean it.

Shark CORDLESS V1900W Specifications

General IconGeneral
BrandShark CORDLESS
ModelV1900W
CategoryBlower
LanguageEnglish