Follow these guidelines to ensure safe operation:
Read this manual and your ATV operator’s manual before use. Follow all warnings and notices.
Before first use, set plow in the furthest right or left angled position to check for clearance between the plow and front tires.
Operate with extreme caution on slopes and rough terrain. Be familiar with the area before you plow.
Be aware of immovable objects that could be hidden in the area you are plowing.
To avoid damage when pushing snow into a pile, reverse direction before raising the plow blade.
Do not ram the plow blade into piles of snow.
For best results, set the suspension preload of your ATV to the stiffest setting.
To reduce steering effort and increase mobility, set the air pressure of your tires to the maximum pressure.
The plow blade assembly is designed to “spring” when it strikes an object or digs in too far.
When pressure is released, the plow springs back into position. Spring tension can be increased by tightening the locknuts on
the bottom of the eyebolts. For less spring tension, loosen the locknuts.
The plow skids are adjustable. General skid setting is even with the plow wear bar bottom edge, higher settings reduce the
chance of rocks and gravel from being collected. More information in this manual.
Periodically check for wear and tightness of all fasteners. Replace or re-torque fasteners as necessary.
To increase traction during plowing, operator can try: Securing weight to the ATV for additional tire down force, reducing tire
air pressure, or installing tire chains.
SAFETY INFORMATION
Our plow systems were designed with your safety in mind. Please read and understand all Cautions, Notices and
Warnings in this manual before you begin. In order to protect you and your ATV, certain parts of the plow system
and/or hardware are designed to fail when the equipment is over-stressed.
To avoid personal injury or damage to your vehicle:
Do not exceed 8 km/h, even with the blade raised
Be aware that vehicle ground clearance is reduced with plow system installed
Keep yourself, other people and pets away from the blade and moving parts during operation
Before adjusting blade angle or disconnecting the plow, stop the engine and set the parking brake.
Remove your plow system before trail riding.
Do not install forward mount system over plastic guard components, which can compress over time and
loosen the installation, resulting in poor product performance and/or damage to the ATV/UTV.
Do not allow forward mount system to interfere with ATV operational items such as brake lines, coolant
hoses, control cables, steering or any other function.
Be sure to lock the adapter´s Pipe Linch pins by turning the resilient catch each time the blade is
attached.
Read and understand all instructions.
Verify all parts and tools required.
Follow all steps correctly and in the sequence described.
To Next Page
Loading...
Need help?
General