BLADE ANGLE ADJUSTMENT
The plow system has 5 positions for blade angle settings. To adjust,
raise the plow from the ground using the winch, then push down on the
handle (Z) and rotate your blade left or right until you reach the desired
angle. Make sure handle is locked in before plowing.
CAUTION:
Regularly check all fasteners and adapter linch pin locks.
During transport, blade must be raised in the transport position so that it does not block the headlights.
Incorrect plow spring tension may reduce blade life.
To avoid damage when plowing delicate surfaces such as interlocking tiles, we recommend you to use
rubber wear bars:
Part No.: 10-0224 for 132cm Plow
Part No.: 10-0225 for 152cm Plow.
If in doubt, consult your authorized Shark dealer.
Official distributor:
ASP Group s.r.o.
Staroplzenecka 290
326 00 Letkov
Czech Republic
Tel.: +420 378 21 21 21
Email: info@aspgroup.cz
Web: www.aspgroup.cz
ASP Group s.r.o. reserves the right to make technical and/or design changes at any time without prior notice. In case of any questions please
contact your Shark dealer.
© 2019Copyright ASP Group s.r.o.
All rights reserved. The content of this manual, any illustrations, technical information and descriptions within this document were correct at the
time of going to print. ASP Group s.r.o. reserves the right to make any changes necessary, without notice, in line with the policy of continuing
product development and improvement. No part of this publication may be duplicated, reprinted, stored in a data processing system or
transmitted by electronic, mechanical, photographic or other means, or recorded, translated, edited, abridged or expanded without the prior
written consent of ASP Group s.r.o.
To Previous Page
Loading...
Need help?
General