persons in order to avoid a hazard.
21. Use extra care when cleaning on stairs.
22. DO NOT leave the vacuum cleaner unattended while plugged in. When powered on, keep the vacuum cleaner
in the upright position and moving over the carpet surface at all times to avoid damaging the carpet fibres.
23. DO NOT place vacuum cleaner on unstable surfaces such as chairs or tables.
24. DO NOT use to pick up: liquids, large objects, hard or sharp objects (glass, nails, screws, or coins), large
quantities of dust (drywall dust, fireplace ash, or embers).
25. DO NOT use as an attachment to power tools for dust collection, such as for smoking or burning objects (hot
coals, cigarette butts, or matches), flammable or combustible materials (lighter fluid, petrol, or kerosene), toxic
materials (chlorine bleach, ammonia, or drain cleaner).
26. DO NOT use in the following areas: poorly lit areas, wet or damp surfaces, outdoor areas, spaces that are
enclosed and may contain explosive or toxic fumes or vapours (lighter fluid, petrol, kerosene, paint, paint
thinners, mothproofing substances, or flammable dust).
27. Turn off all controls before plugging in or unplugging the vacuum.
28. Unplug from electrical socket when not in use and before any maintenance or cleaning.
29. To clean: wipe down the unit with water only. Washing with cleaning chemicals could damage the unit.
30. During cleaning or routine maintenance, DO NOT cut anything other than hair, fibres, or string wrapped around
the brush-roll.
31. Allow all filters to air-dry completely before replacing in the vacuum to prevent liquid from being drawn into
electric parts.
32. Make sure the dust cup and all filters are in place after routine maintenance.
33. Use extra care when cleaning on stairs. DO NOT work with the appliance above you on the stairs.
34. Hold the plug when rewinding onto cable reel. DO NOT allow the plug to whip when rewinding. The plug may
cause injury and damage to surrounding objects if the cable is allowed to rewind without guidance
SAVE THESE INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE
ASSEMBLY
To Next Page
Loading...
Need help?
General
