11
1
2
4
MIN MAX
ENGLISH
P I N L O C K V I S O R ®
1 – Place the visor on a work surface and
on a soft covering. Make sure that the
inner surface of the visor is clean. Use a
coin to check that the external adjustment
levers are positioned inwards (positioned
to «INT»).
2 – Place the PINLOCK® lens on the
visor. The silicone seal of the PINLOCK®
lens must be in contact with the inner
surface of the visor. The PINLOCK® logo
is visible on the outside of the visor.
3 - Insert one side of the PINLOCK® lens
into one of the two pins at the ends of the
visor and hold it in position.
4 – Extend and flex the visor and fit the
second side of the PINLOCK® lens into
the second pin. Release the visor so that it
reacquires its curved shape.
Clean the visor using mild liquid soap,
lukewarm water and a soft damp rag only.
Allow the visor to dry naturally before
reassembling it.
Your D-SKWAL 3 is pre-designed to fit
a PINLOCK®; a flexible plastic lens that
absorbs moisture. When fitted against
your visor, it offers very effective anti-
fog protection. It prevents the formation
of micro-droplets that compromise your
field of view.
To Next Page
Loading...
Need help?
General
