A B
-
REMOVING THE INTERIOR PARTS
We advise you to carry out this operation with
the helmet in the Jet configuration.
- Turn your helmet over;
- Separate the two parts of the chin strap;
- Remove the neck pad by holding one of its
sides; pull out the end and then detach its rear
section (Fig. A);
- Unclip the two cheek pads (Fig. B) and slide
them along the chin straps to extract them;
- Unclip the rear part of the head section
in order to remove it from its housing
(Fig. C -D);
- To complete the operation, unclip the front
of the head section, starting with one side
(Fig. E) and remove the head section.
-
42
To Next Page
Loading...
