TABLETOP MODE
DISASSEMBLY
STORAGE
To detach the fan from the pole, press the
Lift-Away button, then slide the fan head
off the pole.
If grill screw, bolt, or Allen wrench have been lost, see Hardware Specs section for information on how to replace
any hardware.
Spread out the four support legs until they
click into place. Place the fan on a flat, level
surface and begin use.
To convert the
fan to portable,
tabletop mode:
1. Release the fan head
by pressing the lift away
button and carefully
remove the fan from
the pole.
2. Turn the pedestal base
on its side to access
the bolt on the bottom.
Use the included Allen
wrench to rotate the bolt
counterclockwise, then
remove the bolt.
3. Carefully lift the pole to
remove it from the base.
4. Press the small button
on the lower pole to
detach the poles from
one another. Carefully
fold as needed for
storage. DO NOT strain
the cord.
STORAGE TYPE INSTRUCTIONS
Short-term storage indoors (<24 hours)
1. Carefully disassemble the fan OR place the assembled fan in the desired
storage location. Ensure it is out of reach of children and pets.
2. Place the assembled fan in the desired storage location. Ensure it is
out of the reach of children and pets. If there is inclement weather, it is
recommended to bring fan indoors.
Long-term storage indoors (>24 hours)
1. Carefully disassemble the fan OR place the assembled fan in the desired
storage location. Ensure it is out of reach of children and pets.
2. Store the fan indoors when not in use for long periods of time. Ensure it is
stored out of reach of children.
To Next Page
