Shark LA700 - Emptying the Dust Cup; Dust Cup Removal and Debris Disposal; Lint Screen Cleaning and Dust Cup Reinstallation

sharkclean.comsharkclean.com
EMPTYING THE DUST CUP
To remove the Dust Cup, slide up on the release
button located on the side of dust cup handle.
Tilt dust cup forward, then lift to remove.
To reinstall, place the bottom of the dust
cup onto the pod and then tilt until it clicks
into place.
To empty debris into the trash, press the
lower release button and the bottom of the
dust cup will drop open.
Clear debris from the Lint Screen in the dust
cup. Lift the upper release tab at the top of
the dust cup and open the lid. Gently brush
the lint screen to remove debris.
RINSE HEPA FILTER
EVERY YEAR
To remove the HEPA Filter, first pull the tab
on the bottom of the filter door, then lift o
the door. Press the tab on the side of the
HEPA filter and pull out the filter.
To reinstall the door, align the top first, then
press in the bottom until it clicks into place.
RINSE PRE-MOTOR FILTERS
EVERY MONTH
Remove the Dust Cup, then lift out Filters.
Regularly rinse and replace the filters to maintain your vacuum's suction power and to
maximize the eectiveness of the Odor Neutralizer Technology.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electronic parts.
CLEANING THE FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
IMPORTANT: Unplug the power cord before performing any maintenance.
Empty the dust cup each time you vacuum and periodically during cleaning,
when debris in the dust cup reaches the MAX fill line.
Post-Motor
HEPA Filter
Foam
Felt
Filter
Door