Shark LA700 - Cleaning Modes; Vacuum Operating Modes; Accessory Attachment Guide

sharkclean.comsharkclean.com
Select surface setting:
O Power O
I Hard Floor
For hard floors and small area rugs.
II Carpet
For carpets.
NOTE: All accessories are compatible with both the wand and the handle. Included accessories will vary by model.
NOTE: For deep carpet cleaning per ASTM F608,
use setting II (Carpet) with MAX suction.
NOTE: The brushrolls spin in all modes
WHOLE-HOME CLEANING
CLEANING MODES
To engage Brushrolls, select a
surface setting, step on floor nozzle
and tilt handle back firmly.
Step on the pedal on the floor
nozzle to lift o the pod.
Press the Wand Release button
and pull up on the wand to
detach it from the pod.
Press the Handle Release button
and pull up on the handle to
detach it from the wand.
Attach an optional cleaning
accessory to handle or wand.
UPRIGHT MODE LIFT-AWAY MODE
POWER/SURFACE SWITCH
ABOVE-FLOOR—WAND
ACCESSORIES—WAND
ABOVE-FLOOR—HANDLE
ACCESSORIES—HANDLE
Wand
Release
WHOLE-HOME CLEANING
SETTINGS
The Suction Control Slider located on the
handle allows you to adjust the suction
depending on the floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on hard floors.
SUCTION CONTROL
Solid White Lights: The brushrolls are spinning and the unit is working as it should.
Solid Red Lights: There is a jam in the brushroll area. Turn o the vacuum and unplug it,
then remove any blockages in the nozzle.
Flashing Red Lights: The motorized floor nozzle is overheating. Turn o the vacuum, unplug
it, and remove any blockages. Let the vacuum cool down for at least 60 minutes before
restarting. See Troubleshooting section for more information.
Flashing White Lights: The vacuum is operating in an environment that is either too hot or
too cold. This vacuum will only function properly in temperatures ranging from 32°F (0°C)
to 104°F (40°C). Turn the vacuum o and adjust the room temperature.
HEADLIGHT INDICATOR LIGHTS
NOTE: For deep cleaning per ASTMF608 (embedded dirt in carpets), please set to Carpet mode.
NOTE: For maximum suction for above-floor cleaning per ASTM F558, set to Hard Floor mode.
HEADLIGHTS
The headlights will flash or turn red to
indicate issues that need attention.