EasyManua.ls Logo

Shark SpeedStyle - Troubleshooting & Error Codes; Maintenance and Cleaning: Reduction in Airflow; Overheating Issues

Shark SpeedStyle
3 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE/CLEANING
Reduction in airflow.
A change in airow or air power, airow blockages, and/
or visible buildup on the inlet at the back of the unit
could indicate your unit needs to be cleaned. To maintain
performance, clean the filter at the back of the unit every
month, using a new toothbrush.
Removing the Filter
1. Turn o the unit and unplug it. Rotate the filter cover on
the back of the unit counterclockwise, then pull it o.
Then rotate the filter counterclockwise and pull it o.
Cleaning the Filter
1. Soak the filter in warm, soapy water for at least 30
minutes.
2. Wipe down the back of the unit with a dry microfibre
cloth or a new toothbrush to remove the debris.
3. After 30 minutes, remove the filter from the water and
rinse it thoroughly under a tap.
4. Pat the filter dry with a microfibre cloth. Let the filter air-
dry completely for up to 24 hours before reinstalling.
5. To reinstall the filter, reinsert it and rotate it clockwise.
Then align the filter cover and rotate it clockwise until
it fits securely.
OVERHEATING
Hair dryer is overheating or shuts o.
This unit is equipped with a temperature-protective
thermostat. If for some reason your hair dryer overheats,
the thermostat will automatically turn the unit o. To
prevent power-down recurrence, unplug the hair dryer and
set it aside to cool, or press the Cool Shot button during
use. Overheating may result if the unit is powered on for a
long duration. Overheating can also indicate a blockage or
dust buildup. To prevent overheating, clean the filter at the
back of the unit every month, using a new toothbrush. Make
sure you are not covering the filter with your hand when
operating the unit, as this could also cause overheating. If
overheating continues to occur, contact Customer Service
at AUS: +61 2 8801 7666 I NZ: +64 800 112 660.
TROUBLESHOOTING & ERROR CODES
Overheating
Error Code
If you are experiencing a dierent error code, contact Customer
Service at AUS: +61 2 8801 7666 I NZ: +64 800 112 660
Mann&Noble Pty Ltd
Building D, 33 Quarry Road
Erskine Park, NSW, Australia, 2759
AUS: +61 2 8801 7666
NZ: +64 800 112 660
www.sharkbeauty.com.au
www.sharkbeauty.co.nz
E4156

Related product manuals