Shark Vertex DuoClean PowerFins IZ462H User Manual

WHAT’S INSIDE: POWER SETTINGS
CHARGING
ASSEM B LY
A
B
C
2
(Click)
1
(Click)
OFF
HARD FLOOR
SETTING
CARPET SETTING BOOST MODE
Slide switch to the
top to turn o power.
To begin vacuuming,
slide switch to the
appropriate setting.
Slide switch to the
middle. The brushrolls
spin slowly to clean
hard floors and low-pile
arearugs.
Slide switch to the
bottom. The brushrolls
spin faster to pick up
debris below the surface
ofyour carpets.
For an added boost in
power, pull the Trigger
on the handheld vacuum.
Release it to return to
standard power.
LITHIUM-ION POWER PACK
NOTE: The Lithium-Ion Power Pack battery
comes partially charged. Charge fully before
first use, then run the battery down until it is
completely out of power. This will condition the
battery so the LED indicators will work properly.
Battery Indicator Lights
In Use
Full
Charge
Mid
Charge
Low
Charge
Nearly
Empty
No
Charge
Charging
Low
Charge
Mid
Charge
Nearly
Full
Full
Charge
NOTE: Full charge takes approximately 3 hours.
FE
G H I
D
A
Handheld Vacuum
B
MultiFLEX® Wand
C
DuoClean® PowerFins Floor Nozzle
D
Crevice Tool
E
Pet Multi-Tool
F
Anti-Allergen Brush
G
Lithium-Ion Battery (Pre-Installed)
H
Charger
I
HEPA Post-Motor Filter (Pre-Installed)
OUT OF THE VACUUM
IN THE VACUUM: MULTIFLEX® WAND
For additional parts and accessories, visit sharkclean.com
To put the vacuum in storage mode, press the MultiFLEX
Lock Release button while folding the handheld vacuum
forward until the wand clicks and locks. Plug the charger
into the charging port on the battery.
To remove the battery, press the Battery Release
button and slide out the battery. Plug the charger
into the charging port on the battery.

Shark Vertex DuoClean PowerFins IZ462H Specifications

General

Type	Cordless Stick Vacuum
Battery	Lithium-ion
Run Time	Up to 60 minutes
Weight	9.04 lbs
Filtration	HEPA
Cordless	Yes
Voltage	25.2V
Charging Time	3.5 hours
Features	DuoClean PowerFins, LED headlights