06
Install the ledge cover
Place ledge cover over the top plate and push downward un l the side hooks
snap in place. (image 30)
Install screw covers
The arrows must point toward the inside of the pool.
Match each screw cover, right (R) and le
(L) with proper screw cavity
on top ledge and snap in place. (image 29)
29
30
Finish Įlling the pool
Turn oī the vacuum (if using) and carefully remove it from the pool.
Fill the pool with water to 2’’ (5cm) below the lowest opening. Make sure you
remove any creases from the liner in the bo
om of the pool before the water
level gets too high.
Your pool is now installed. You must now install the Įlter and pump, the skimmer
and water return inlet. Please follow the installa
on instruc ons that com
e with
these products.
IMPORTANT NOTE:
Before making any openings in the liner, Įll the pool with 24’’ (60cm) of water to stretch the liner fully.
When Įlling your pool, begin with a garden hose un l there is about 12’’ (30cm) of water in the pool.
This will allow the liner to stretch gradually. You can then use a heavier Ňow to Įnish Įlling it up.
ASSEMBLING THE POOL FRAME
To Next Page
Loading...
