Media Reader All-in-One
2.3 System Requirements
• USB 3.0 port (Type A port)
• Supported operating systems: Windows 7/8/10, Mac OS X
3. Package Contents
• Media Reader All-in-One
• USB 3.0 cable (Type A plug to Micro-B plug))
• Manual
Note:
Should any of the above items be missing, please contact our customer service immediately:
support@sharkoon.com (Germany and Europe
support@sharkoon.com.tw (International)
4. Installation
Connect the Micro-B plug on the included cable to the Media Reader All-in-One Card Reader. Then connect
the USB Type-A plug on the cable to an available USB port on your notebook, PC, MacBook or MacBook Air.
The driver for the card reader will install automatically, afterwards the device is available for use.
Using the Card Reader:
The All-in-One Card Reader supports hot-swap. As a result, memory cards can be inserted or removed at any
time. Once a memory card is inserted into a slot of the card reader, then the data can be accessed to copy,
read or delete. In addition, data transfer is supported between memory cards inserted into the other card
reader slots.
Note:
To prevent against the loss of data, do not remove the memory card while in the process of reading or writing
process.
To Next Page