servis +420 774 335 397 www.sharks-shop.cz Stránka 20
DESCRIPTION
1. body helmets
2. head fixation
3. fixation/clamping settings
4. angle settings
5. shade settings
6. cover plate
7. solar panel
8. fixed plate
9. pressure plate
10. UV/IR filter
OPERATING INSTRUCTIONS
Set the size headband
The tightness of the headband is adjustable compression of the clamping wheels. Rotate You can set
the desired level of comfort. This crimping wheel is located at the rear of the helmet.
Set the top of the headband masks
Performed vertical adjustment of the upper tape head strap and the securing pin into the hole and thus
the desired position.
Tilt
The inclination can be set on the left side of the helmet. The inclination can be adjusted by loosening
the tension of the outer knob/wheel clamping, loosening the adjusting lever from the current position
and putting it into the desired position. After setting back the outer clamping knob securely.
Changing the front cover plate
If the front cover plate damaged, scratched or dotted with holes, replace it. Place a finger or thumb into
the recess "C" on the bottom edge of the cover plate and slide the plate bend upward until it
disengages from the edge.
Replacing the interior protective film
If damaged, cracked, dirty or damaged sockets, place your finger in the recess of the cassette, slide
the visor and bending sheet up until the edge / notch releases.
To Next Page
Loading...