SHARKS Devil - Maintenance and Filter Features; Cleaning and Storage; Welding Filter Features

servis +420 774 335 397 www.sharks-shop.cz Stránka 21
Cleaning
Helmet clean by wiping with a soft cloth. Regularly clean the surface of the cartridge. Do not use
aggressive cleaning solutions. Sensors and solar cells clean with a solution of soapy water and a
clean cloth, dry the surface with a clean cloth. Do not insert the cartridge into the water or other
solutions.
Storage
Balaclava Always store in a clean, dry place and protect it from moisture and extreme heat (min/max.
Storage temperature is -20 ℃ ~+ 70 ℃).
OPERATION WELDING FILTER/FEATURES
Variable control shielding
The shield may be necessary depending on the welding process and application set from the aperture
9 at the 13th Control rotary screw aperture is positioned on the surface of the helmet shell.
Grinding function
Grinding mode is intended for cutting and not for welding.
Sensitivity control
The light sensor can be adjusted by turning the adjusting screw/knob to adjust the sensitivity right or
left. Generally, turning the screw ever higher sensitivity setting is for normal use better choice. When
the hood is used excessive ambient light, or near another welding equipment, you can achieve better
performance hoods lower settings - reducing sensitivity using the adjustment screw.
Setting delay
This operation is designed to protect the welder's eyes from the harsh rays of the residual after the
completion of welding. Changing the settings of the adjusting screw of delay will vary with time
changes darkness to light from 0.1 seconds (minimum) to 1.0 seconds (maximum). Maximum (1.0
seconds) is recommended value when using high amperage when welding weld after an interruption
still very clear and also in situations where the filter can be, due to the welding arc, temporarily
blocked.
Power
This helmet is powered by solar energy.
BEFORE WELDING ALWAYS TRY THE TEST CHARGE TAPE!
Helmet may be to charge the article placed on the solar radiation. When charging charges the ADF
cartridge welding arc.
1. LCD filter panel
2. control delay settings
3. control sensitivity settings
4. Sensor
5. Solar cell
6. UV/IR darkering filter
7. Replaceable Lithium Battery
( 2 pcs CR2032)