Sharp 13N-M100B User Manual

1
13N-M100B/150B
CN13M10B
COLOR TELEVISION
Chassis No. SN-010
In the interests of user-safety (Required by safety regulations in some countries) the set should be restored to its
original condition and only parts identical to those specified should be used.
SX0K513N-M100
» ELECTRICAL SPECIFICATIONS .........................................................................................................1
» IMPORTANT SERVICE SAFETY PRECAUTION .................................................................................2
» LOCATION OF USER'S CONTROL .....................................................................................................6
» INSTALLATION AND SERVICE INSTRUCTIONS ................................................................................7
» CHASSIS LAYOUT .............................................................................................................................13
» BLOCK DIAGRAM ..............................................................................................................................14
» SCHEMATIC DIAGRAMS ...................................................................................................................15
» PRINTED WIRING BOARD ASSEMBLIES ........................................................................................21
» REPLACEMENT PARTS LIST............................................................................................................24
» PACKING OF THE SET ......................................................................................................................31
Page
SHARP CORPORATION
CONTENTS
SERVICE MANUAL
This document has been published to be used for after
sales service only.
The contents are subject to change without notice.
MODELS
POWER INPUT .................................................... 120 V AC 60 Hz
POWER RATING ................................................................... 53 W
PICTURE SIZE ............................................. 580cm
2
(89.8sq inch)
CONVERGENCE ............................................................. Magnetic
SWEEP DEFLECTION .................................................... Magnetic
FOCUS ............................................... Hi-Bi-Potential Electrostatic
INTERMEDIATE FREQUENCIES
Picture IF Carrier Frequency ..................................... 45.75 MHz
Sound IF Carrier Frequency ...................................... 41.25 MHz
Color Sub-Carrier Frequency .................................... 42.17 MHz
(Nominal)
AUDIO POWER
OUTPUT RATING ................................ 0.9W (at 10% distortion)
ELECTRICAL SPECIFICATIONS
SPEAKER
SIZE ...................................................................... 8 cm (Round)
VOICE COIL IMPEDANCE............................. 32 ohm at 400 Hz
ANTENNA INPUT IMPEDANCE
VHF/UHF.....................................................75 ohm Unbalanced
TUNING RANGES
VHF-Channels...............................................................2 thru 13
UHF-Channels ............................................................14 thru 69
CATV Channels ...........................................................1 thru 125
(EIA, Channel Plan U.S.A.)
Specifications are subject to change without
prior notice.
13N-M100B/150B
CN13M10B

Sharp 13N-M100B Specifications

General

Brand	Sharp
Model	13N-M100B
Category	TV
Language	English

Summary

ELECTRICAL SPECIFICATIONS

IMPORTANT SERVICE SAFETY PRECAUTION

WARNING

Critical warnings for technicians performing service on the TV.

X-RADIATION AND HIGH VOLTAGE LIMITS

Precautions and limits regarding X-radiation and high voltage.

BEFORE RETURNING THE RECEIVER

SAFETY NOTICE

LOCATION OF USER'S CONTROL

Front Panel Controls

Identification and function of controls on the TV's front panel.

Basic Remote Control Functions

Explanation of basic functions performed by the remote control.

INSTALLATION AND SERVICE INSTRUCTIONS

CIRCUIT PROTECTION

Information about the receiver's circuit protection fuse.

X-RADIATION PROTECTOR CIRCUIT TEST

Procedure to test the X-radiation protection circuit.

HIGH VOLTAGE CHECK

Procedure to check the high voltage output of the TV.

SERVICE ADJUSTMENT

Entering and Exiting Service Mode

Steps to access and leave the TV's service mode.

Service Number Selection

How to navigate and select adjustment categories in service mode.

SERVICE ADJUSTMENT

+B Adjustment

Procedure for adjusting the +B voltage.

RF AGC Adjustment

Procedure for adjusting the RF Automatic Gain Control.

Video Level Adjustment

Procedure for adjusting the TV's video signal level.

SERVICE ADJUSTMENT (Continued)

Vertical-Size, V-Linearity, V-S Correction Adjustment

Adjustments for vertical picture geometry.

Horizontal Position Adjustment

Procedure to adjust the horizontal picture centering.

Caption Position Adjustment (Horizontal)

Procedure to adjust the horizontal position of captions.

CHASSIS LAYOUT

BLOCK DIAGRAM

SCHEMATIC DIAGRAM: MAIN Unit (PWB-A Part 1)

SCHEMATIC DIAGRAM: MAIN Unit (PWB-A Part 2)

SCHEMATIC DIAGRAM: CRT Unit

PRINTED WIRING BOARD ASSEMBLIES: CRT Unit

PRINTED WIRING BOARD ASSEMBLIES: MAIN Unit

PARTS LIST

PARTS REPLACEMENT

Information on replacement parts with special safety characteristics.

HOW TO ORDER REPLACEMENT PARTS

Instructions for ordering replacement parts correctly.

PACKING PARTS

CABINET PARTS

PACKING OF THE SET