Sharp 14J1-RU - Basic Operation; Turn on the Power; Channel Selection; Adjusting Volume

Remote control
TV/VIDEO
TV
0
NORMAL
TIMERFEATURE
CH-SET
PICTURE
1
4
7
2
5
8
3
6
9
CH
CH
Infrared transmitter window
Aim this window at the infrared
sensor window on your TV set
.
Turns the TV on or to Standby mode.
Returns to previously viewed channel.
Mutes the sound and restores
sound to previous level
.
Calls the TIMER screen.
TIMER
Calls the FEATURE screen.
FEATURE
Resets all settings.
NORMAL
Calls the CH-SETTING screen.
CH-SET
Switches between TV broadcasts
and A/V input programmes
.
TV/VIDEO
Switches between one- or two-digit
mode channel selection.
Calls the PICTURE screen.
PICTURE
Adjusts the volume.
Used for MENU setup
.
/
Displays the channel and timer
settings on the screen.
Number buttons
Selects the channel.
Used for MENU setup
.
CH
CH
/
Installing batteries in the remote control unit
With your thumbnail, pull
up at the slit to open the
battery cover.
a
[ TV Set (Bottom) ]
Power indicator
POWER
Turn on the power
• When the power indicator is off, press
POWER
.
• When the power indicator lights up dimly, press on the remote
control. The power indicator changes to bright and a picture appears.
On-screen display language selection
ENGLISH
TV set
• Press
MENU/PRESET
for more than two seconds, the language
select mode appears.
• Press
CH
/
CH
to select desired language.
• Pressing
MENU/PRESET
changes the screen as shown below.
• Press
MENU/PRESET
until normal screen appears.
! Adjust volume using / .
• The volume bar disappears approximately three seconds
after the volume has been adjusted.
! Using
CH
/
CH
• Press
CH
and channels change as shown below.
1 / 2 / ... / 98 / 99 / AV1 / AV2 / 0 / 1 / 2 ...
• Press
CH
and channels change as shown below.
1 / 0 / AV2 / AV1 / 99 / 98 / ... / 2 / 1 / 0 ...
@ With the number buttons (on remote control)
• To select a one-digit channel, such as 5, press
5
. If
“5-” is indicated, press to select one-digit input,
and then press
5
again.
• To select a two-digit channel, such as 15, press
to select the two-digit input. Press
1
, and then
press
5
.
VOLUME 10
--
1-
15
SECAM
D/K
CH
MENU/PRESET
CH
CH
[ TV set (Bottom) ]
Insert two batteries
(size AA).
b
Replace the battery
cover.
c
TV/VIDEO
TV
0
NORMAL
TIMERFEATURE
CH-SET
PICTURE
4
7
2
8
3
6
9
CH
CH
1
5
CH
CH
1
5
Channel selection
Adjusting volume
• When the power indicator lights up dimly, either
CH
/
CH
on the TV can be pressed to turn on the power.
• Channels that have been skipped cannot be selected by
CH
/
CH
.
• The AV1, AV2 input channels cannot be selected using
CH
/
CH
on the remote control. Use
TV/VIDEO
to select
these channels.
E5 BASIC OPERATIONE4 PART NAMES (Continued)
Language MANUAL
Normal screen
AUTO
21J1-RU[EN] 7/9/05, 11:22 am3