3
37GT-25S
ELECTRICAL SPECIFICATIONS
•Power Input .......................220V-240 Volts AC 50Hz
•Power Consumption
•Audio Power Output Rating .....................2W (MPO)
Speaker............................32
Ω 2W, 8cm Round, 1pc
Normal Operation....................................34W
Stand-by Operation................................7.0W
•White Level
Set the brightness control, with no signal connected, so that the CRT cathode current is 600mA. The maximum
correction applied to each cathode current to achieve a screen temperature of 8550 degrees K-1 MPCD should not
exceed 15% of its original value.
X=0.290 Y=0.300
WARNING
The chassis in this receiver is partially live, always use an isolation transformer when
servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer
servicing to qualified service personnel.
Convergence.........................Self Converging System
Focus....................................Bi-Potencial Electrostatic
Sweep Deflection...........................................Magnetic
Specifictions are subject to change without prior notice.
•Aerial Input Impedance
VHF/UHF...........................75 ohm Unbalanced
•Tuning Ranges .............48.25MHz thru 855.25 MHz
VHF.........................................CH02-CH12, S1-S41
UHF.......................................................CH21-CH69
•Picture Intermediate Frecuency.......
.........38.9MHz
•Sound Carrier Trap.............................33.4MHz
•Adjacent Sound Carrier Trap................40.4MHz
•Adjacent Picture Carrier Trap...............31.9MHz
To Next Page
Loading...
