Sharp AH-X075E - Page 43

AH-X07SE/X095E
AU-X075SE/X095E
AY-X075E/X09SE
AE-X075E/X00SE
6.
Disconnect
the
connector.
(4
places)
9.
Remove
2
screws
which
fasten
the
motor
angle.
Disconnect
the
Faston
terminal.
(10
places)
Pull
up
the
motor
angle
for
removal.
(During reassembling, treat the lead wire to prevent it
from being in contact with the propeller fan.)
10. Remove 3 motor fastening screws, and remove the
motor.
Remove the 2 screws of the control PWB, and the control
circuit will be ready for removal from the control box.
7. Remove 2 fastening screws of the control box. 11. Remove the bulk head.
Remove
2
small
screws
which
fasten
the
ground
cable.
Remove
2
fastening
screws.
Lifting
the
bulk
head,
remove
Remove the electric battery box. 2 inner hooks.
Lf}
it
H)
i
bn}
i
i
i
i
0
i
8. 12. Remove 2 screws which fasten the choke coil, and
remove the choke coil.