Example
5 To update the TV software with the update file, select
"Yes", and then press ENTER.
• Do not remove the USB memory device or unplug the
AC cord while the software is being updated.
6 When the software is successfully updated, a screen is
displayed indicating that the update process is
completed.
After this screen is displayed, the TV automatically turns
off and then turns on again.
• If the update has failed, check the file in the USB
memory device and try Software Update again.
7 After the screen shown below is displayed, press
ENTER.
8 Remove the USB memory device.
Updating the Software via the Network
1 Press _idVon the Manual Update screen to select
"Network Update", and then press ENTER.
• The TV connects to the network and checks for
updates.
• To cancel, press ENTER.
2 The current version of the TV and the latest version of
software are displayed. To update the TV software,
select "Yes", and then press ENTER.
• When a server connection cannot be established or an
update is not available, a message is displayed.
If a server connection cannot be established, check
the broadband connection and Intemet Setup.
3 After the update file is downloaded, the software update
process begins.
• Do not unplug the AC cord while the software is
being updated.
4 When the software is successfully updated, a screen is
displayed indicating that the update process is
completed.
A screen indicating that the update is completed is
displayed. 4 seconds later, the TV restarts automatically.
• If the software was not updated successfully, check the
broadband connection and Internet Setup, and then try
updating the software again.
Displays software version information.
Displays the built-in operation manual on the screen. You
can read information about how to use this device.
ENG 4-34
To Next Page
Loading...
