Sharp AR-5620D - System Settings Details (Cont.)

71
USER SETTINGS
6
7 Rotation copy
0: OFF
1: ON
• When the auto paper select function is
enabled and there is no paper that is the same
size as the original and loaded in the same
orientation, this function will automatically
select paper of the same size that is loaded in
the opposite orientation, and rotate the image
90 degrees so that it is copied on the paper in
the correct orientation.
• When the auto ratio select function is
operating and the original and paper are
loaded in opposite orientations, this function
rotates the image so that it is copied on the
paper in the correct orientation.
8
Auto paper select
mode
*2
0: OFF
1: ON
• This function automatically selects paper that
is the same size as the original placed in the
SPF/RSPF, or the same size as that selected
with the [ORIGINAL] key ( ). The
function can be disabled.
9 Auto tray switching
*2
0: OFF
1: ON
• If the paper runs out during printing and there
is paper of the same size and orientation in
another tray, this function automatically
switches to that tray (excluding the bypass
tray). The function can be disabled.
10 to 15 Auditing mode – See "AUDITING MODE SETTINGS" (p.75).
16
Erase width
adjustment
1: 0 mm (0")
2: 5 mm (1/4")
3: 10 mm (1/2")
4: 15 mm (3/4")
5: 20 mm (1")
• Use this setting to set the width of erasure of
shadows that appear around the edges and at
the binding margin when a book or similar
original is copied.
17 Layout in 2 IN 1 copy
1: Pattern 1
2: Pattern 2
• Use this setting to select the layout pattern
when two original pages are copied onto a
single sheet of paper (see page 44 for the
layout patterns).
18 Layout in 4 IN 1 copy
1: Pattern 1
2: Pattern 2
3: Pattern 3
4: Pattern 4
• Use this setting to select the layout pattern
when four original pages are copied onto a
single sheet of paper (see page 44 for the
layout patterns).
20
Image rotation in
duplex copying
*3
0: OFF
1: ON
• When a one-sided vertical (portrait) original is
placed in a horizontal orientation (B4 or A3
(8-1/2" x 14" or 11" x 17") size) for two-sided
copying, the top and bottom of the images on
the front and back of the paper will be opposite
to each other.
21
Location of the
margin
*3
1: Left edge
2: Top edge
• Use this setting to switch between the margin
at the top edge and the margin at the left edge.
22 Margin width
1: 0 mm (0")
2: 5 mm (1/4")
3: 10 mm (1/2")
4: 15 mm (3/4")
5: 20 mm (1")
• Use this setting to set the margin width.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation
*
2
When there are two or more paper trays.
*
3
When the RSPF is installed.