Sharp AY-X095E - Maintenance Procedures; Filter Cleaning Guide

Be
sure
to
unplug
the
power
cord
from
the
wall
outlet
or
turn
off
the
circuit
pieaker
before
performing
any
maintenance.
CLEANING
THE
FILTERS
The
air
filters
should
be
cleaned
every
two
weeks.
1 TURN OFF THE UNIT
2 REMOVE THE FILTERS
1 Lift up the panel.
2 Push the air filters up slightly to unlock them.
3 Pull the air filters down to remove them.
CLEAN THE FILTERS
Use
a
vacuum
cleaner
to
remove
the
dust.
/f
the
filters
are
dirty,
wash
them
with
warm
water
and
a
mild
detergent.
Dry
the
filters
in
the
shade
before
reinstalling.
g REINSTALL THE FILTERS
neem
=
Say
1
Reinstall
the
filters.
4 2 Close the panel.
off
LL
{|
i]
3
Push
the
center
of
the
panel
firmly
to
lock
it
in
(21
=
place.
CLEANING
THE
UNIT
AND
THE
REMOTE
CONTROL
¢ Wipe them with a soft cloth.
*
Do
not
splash
or
pour
water
on
them.
It
could
result
in
electrical
shock
or
damage
to
them.
¢
Do
not
use
hot
water,
thinner,
abrasive
powders
or
strong
solvents.
POST-SEASON
CHECK
PRE-SEASON
CHECK
1 Operate the unit in the FAN ONLY
mode for about half a day to allow the
mechanism to thoroughly dry.
Make sure that the air filters arenot
dirty.
2 Make sure that nothing obstructs the
air inlet or outlet.
3 Check the outdoor mounting rackpe-
riodically for wear and to make sue it
is firmly in place.
2 Stop the operation and unplug the
unit. Turn off the circuit breaker, if you
have one exclusively for the air condi-
tioner.
3 Clean the filters, then reinstall them.
E-13