Sharp BP-30M28 User Manual

18
BEFORE USING THE MACHINE
LOAD PAPER INTO THE TRAY 1 - 4
1
Pull out the paper tray.
Gently pull the tray out until it stops.
Push the centre of the pressure plate down until it locks into
place.
Tray 1 and tray 2 cannot be pulled out at the same time.
2
Adjust guide plates A and B to match
the longitudinal and transversal
dimensions of the paper to be loaded.
The guide plates A and B are slidable. Squeeze the
separator plate lever and slide to the desired paper size.
3
Insert the paper into the tray.
• Load the paper with the print side facing up. Make sure
the stack of paper is straight before loading it.
• Fan the paper well before loading it. If the paper is not
fanned, multiple sheets may feed at once and cause a
misfeed.
• After loading the paper, close the guides to the paper
width not to leave the gap from the guides A and B.
• Do not load the paper as shown below.
4
Gently push the paper tray into the
machine.
Push the tray firmly all the way into the machine slowly.
Forcefully inserting the paper may cause skewed feeding
and paper misfeeds.
A
B
Indicator
Line

Sharp BP-30M28 Specifications

General

Functions	Print, Copy, Scan
Print Speed (Black)	28 ppm
Print Resolution	600 x 600 dpi
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Yes
Copy speed Black A4 (max ppm)	28 ppm
Paper Capacity	350 sheets
Interface	USB 2.0
Paper Size	A4, A5, B5
Memory	2 GB
Original paper size	A4
Scan Speed (Mono)	37 ipm
Scan Speed (Colour)	37 ipm
First print out time (Black)	Less than 10 seconds