18
BEFORE USING THE MACHINE
LOAD PAPER INTO THE TRAY 1 - 4
1
Pull out the paper tray.
Gently pull the tray out until it stops.
Push the centre of the pressure plate down until it locks into
place.
Tray 1 and tray 2 cannot be pulled out at the same time.
2
Adjust guide plates A and B to match
the longitudinal and transversal
dimensions of the paper to be loaded.
The guide plates A and B are slidable. Squeeze the
separator plate lever and slide to the desired paper size.
3
Insert the paper into the tray.
• Load the paper with the print side facing up. Make sure
the stack of paper is straight before loading it.
• Fan the paper well before loading it. If the paper is not
fanned, multiple sheets may feed at once and cause a
misfeed.
• After loading the paper, close the guides to the paper
width not to leave the gap from the guides A and B.
• Do not load the paper as shown below.
4
Gently push the paper tray into the
machine.
Push the tray firmly all the way into the machine slowly.
Forcefully inserting the paper may cause skewed feeding
and paper misfeeds.
To Next Page
Loading...
Need help?
General
