Page 2
Service Success Center: https://service.sharpamericas.com/
Sharp Academy: https://satech.sharpamericas.com/Sharp-Academy
Questions? Contact us at success@sharpsec.com
Find the appropriate Manual and section for the Inner Finisher removal, and follow
the steps to:
1. Remove the Finisher from the Main Unit.
2. Remove the Rear Cover.
3. Perform Component ID and note the differences between the BP-FN11 and the BP-
FN12.
4. Remove the Stapler unit.
5. Reinstall the Stapler unit.
6. Remove the Upper Feed Guide unit.
7. Remove the Staple-less Staple unit.
8. Reinstall the Staple-less Staple unit.
9. Reinstall the Upper Feed Guide unit.
10. Reassemble the Finisher.
11. Reinstall the Finisher.
12. Make copies in all modes to verify Finisher and Punch unit operation.
To Next Page
Loading...