• Memorizing a station
You
can
store 40
AM
and
FM
stations
in
memory and recall them at
the push of a button. (Preset tuning)
1 Perform
steps
1 - 3 in
"Tuning"
on page
24.
2 Press the MEMORY button
to
enter the preset tuning
saving mode.
3 Within 1 minute, press the
~
or
~
button
to
select the
preset channel number.
Store the stations
in
memory,
in
order, starting with preset
channel
1.
4 Within 1 minute, press the
MEMORY
button
to
store that
station in memory.
If
the preset number indicators disappear before the station is
memorized, repeat the operation from step
2.
5 Repeat steps 1 - 4
to
set other stations,
or
to
change a
preset station.
When a new station is stored
in
memory, the station previously
memorized for that preset channel number will be erased.
Note:
The backup function protects the memorized stations for a few hours
should there be a power failure or the
AC
power cord becomes
disconnected.
• To recall a memorized station
Press the
~
or
~
button for less than 0.5 seconds to select the
desired station.
• To scan the preset stations
The stations saved
in
memory can be scanned automatically.
(Preset memory scan)
1 Press the
~
or
~
button for more than 0.5 seconds.
The preset number will
flcfsh
and the programmed stations will be
tuned
in
sequentially, for 5 seconds each.
2 Press the
~
or
~
button again when the desired
station
is
located.
'oes§
~~m
88
(§)08§
0':"080
8
EMORY
--8
SHARP
~
• To erase entire preset memory
1 Press and hold the CLEAR button for more than 3 seconds.
"TUN CLEAR" will be displayed.
2 Within 10 seconds, press the MEMORY button.
"COMPLETE" will be displayed.
DK-A10
DK-A10BK
25
To Next Page
Loading...
