– 3 –
POWER SWITCH
PRINT/ITEM COUNT MODE SELECTOR:
“P” (Print mode): The calculator functions as a print/display calculator.
“•” (Neutral): The calculator functions as a display calculator. (Non-
print mode)
“P
•
IC”: The calculator functions as a print/display calculator with an item
counter.
The counter will count the number of times that
+
=
has been
pressed in addition.
Note: • Each time is used in subtraction, 1 will be subtracted from the
count.
• The count is printed when the calculated result is obtained.
• Pressing of
CE
＊
, or clears the counter.
• The counter has the capacity of a maximum of 3 digits (up to ±999).
If the count exceeds the maximum, the counter will recount from
zero.
CONSTANT/ADD MODE SELECTOR:
“K” : The following constant functions will be performed:
Multiplication: The calculator will automatically remember the first number
entered (the multiplicand) and instruction.
Division: The calculator will automatically remember the second
number entered (the divisor) and instruction.
“•” : Neutral
“A” : Use of the Add mode permits addition and subtraction of numbers
without an entry of the decimal point. When the Add mode is activated,
OPERATING CONTROLS
CONTENTS
Page
• OPERATING CONTROLS ........................................................................................3
• INK ROLLER REPLACEMENT ................................................................................ 7
• PAPER ROLL REPLACEMENT ................................................................................8
• ERRORS .................................................................................................................. 9
• SPECIFICATIONS ....................................................................................................9
• CALCULATION EXAMPLES ................................................................................... 34
To Next Page
Loading...
