12/8/1 GX-M10H_OM_EN.fm
10
9
8
7
6
5
4
3
2
1
E-6
General control
Press the ON/STAND-BY button to turn the power on.
The display and subwoofer light can be changed.
Main unit:
1) Press DEMO/(DIMMER)/ button for more than 3 seconds.
The current mode will be displayed.
2) Within 5 seconds, press DEMO/(DIMMER)/ button to
change the mode.
Remote control:
Press DEMO/DIMMER button to change the mode.
Notes:
●
During battery/DC operation, the unit will be set to Demo
mode off with display and subwoofer light in MODE 2 to
reduce the battery power consumption.
●
During MODE 2, press any button to light up the display
backlight for a few seconds.
If you turn off and on the main unit with the volume set to 27 or
higher, the volume starts at 16 and fades in to the last set level.
Press VOLUME +/– buttons (on main unit) or VOL +/– (on
remote control) to increase or decrease the volume.
When you press any of the following buttons, the unit turns on.
●
iPod / , CD / , USB / on the main unit or the
remote control: selected function is activated.
●
TUNER/AUDIO IN on the main unit: last tuner or audio
function is activated
●
TUNER or AUDIO IN on the remote control: the unit turns
on with the selected function activated.
The main unit will enter the stand-by mode (when iPad, iPod ,
iPhone, guitar or microphone is not connected) after 15
minutes of inactivity during:
iPod: Not docked.
Audio In: No detection of input signal.
CD: In the stop mode or no disc.
USB: In the stop mode or no media.
Note:
However, if iPod or iPhone is docked, the unit will begin
charging. “iPod CHARGING” will be displayed.
The auto resume function will resume the last function and
playback, should there be a power failure or the AC power
lead becomes disconnected. However, CD/MP3 programme
and random mode are not memorised.
When the EQ/(X-BASS) button is pressed, the current mode
setting will be displayed. To change to a different mode, press
the EQ/(X-BASS) button repeatedly until the desired sound
mode appears.
The volume is muted temporarily when pressing the button
on the remote control. Press again to restore the volume.
When the power is first turned on, the unit will enter the extra
bass mode which emphasises the bass frequencies, and
“X-BASS” will appear. To cancel the extra bass mode, press
the EQ/(X-BASS) button. The last equaliser mode will turn on.
To turn on the X-Bass mode again, press the EQ/(X-BASS)
button for more than 2 seconds.
Setting the clock (
Remote
control only)
In this example, the clock is set for the 24-hour (0:00) display.
■ To turn the power on
After use:
Press the ON/STAND-BY button to enter the power stand-
by mode.
■ Display and Subwoofer light up control
■ Volume auto fade-in
■ Volume control
■ Direct key power on function
■ Auto power off function
PORTABLE MUSIC BOOMBOX GX-M10
REMOTE
SENSOR
TIMER
MODE 1
MODE 2
MODE Off
(Display backlight on and Subwoofer light off)
(Display backlight on and Subwoofer light on)
(Display backlight off and Subwoofer light off)
■ Auto resume function
■ Equaliser
No equalisation.
For rock music.
Vocals are enhanced.
For hip hop music.
For salsa music.
For reggae music.
■ Muting
■ X-Bass control
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the ENTER button. To adjust
the time, press the or button and then
press the ENTER button.
4
Press the or button to select 24-hour or
12-hour display and then press the ENTER button.
The 24-hour display will appear.
(0:00 - 23:59)
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
ROCK
FLAT
VOCAL
HIP HOP
REGGAE
SALSA
To Next Page
Loading...
Need help?
General
