2727
DVD Setup
Applies to TV models with built in DVD player only.
DVD SETUP
TV Display - Choose from the following options 
4:3 Pan scan   PS Traditional picture format, often used on old fi lm 
4:3 Letter box   LB Traditional picture which has been adapted for widescreen 
Wide   16:9 Widescreen picture format 
TV Type - Choose from the following options 
PAL  For discs from UK/Europe, Asia, Australia etc 
Multi  For both NTSC and PAL 
NTSC  For discs from North America, Japan etc 
Speaker Setup - Choose from the following options
LT/RT    Converts from multi-channel sound to mono 
Stereo    Converts from multi-channel sound to stereo
 
Default - Choose from the following options
Reset   Resets all options in the ‘DVD setup’ menu back to the default settings
Dynamic Range - This is the difference between the quietest and loudest sounds. This setting works only 
with DVD discs recorded in Dolby digital.
Full   Set this to listen with the range recorded on the disc     
3/4   Set this to listen with a range equivalent to a normal television     
1/2   Set this to listen with a smaller difference between the maximum and minimum volume
1/4   Set this to listen with a smaller difference between the maximum and minimum volume
Off  Set  dynamic range to off     
Dual Mono - Choose from the following options
Stereo             Outputs 2 channels of sound both left and right      
Mono L             Outputs left side sound           
Mono R             Outputs right side sound           
Mix Mono            Outputs a single channel of sound but mix between right and left   
Tip: This TV/DVD player is pre-set to play Region 2 DVDs. In the event you wish to use the TV/DVD 
in  another country that uses different region discs, please visit www.umc-uk.co.uk. Select ‘Product 
Support’, ‘Changing Region’.
To enter this menu please ensure the TV is in DVD source & press [DVD SETUP]
If you wish to make changes to any of the default settings, use the scroll  
buttons. 
To confi rm any settings press [OK] button. To exit this menu at anytime, press [DVD SETUP] button.
Sharp - User Guide - 4041K - SHA-MAN-0214.indd   Sec1:27Sharp - User Guide - 4041K - SHA-MAN-0214.indd   Sec1:27 20/04/2017   16:53:0320/04/2017   16:53:03