Sharp LL-T15G1 - Chapter 3. Disassembly and Assembly

LL-T15G1/E15G1 DISASSEMBLY AND ASSEMBLY
3 – 1
CHAPTER 3. DISASSEMBLY AND ASSEMBLY
H
2
A
B
B
C
C
C
A
1
A
A
D
D
3
E
E
K
K
K
G
G
K
d
e
7
g
f
b
c
e
g
f
d
E
5
a
4
a
F
F
b
c
C
C
C
J
C
2
6
h
h
h
i
i
10
9
8
1. SEPARATING THE LCD FROM THE STAND
1) Remove the screw A and the two screws H, then, remove the hinge cover 2.
2) Remove the four screws B to separate the LCD from the stand.
3) Remove the two screws C and remove the hinge.
4) Remove the two screws i and disassembly the stand.
2. THE LCD SECTION
1) Remove the four screws A and the two screws C, then, remove
the rear panel 1.
2) Remove the two lock screws J and the six screws C, then,
remove the main board shield 2.
3) Remove the four screws F and remove the connector b, c, a
and h, then, remove the main board 6.
4) Remove the four screws D, then, remove the inverter shield 3.
5) Remove the four screws G and remove the connector d, e, f
and g, then, remove the inverter board 7.
6) Remove the three screws E, then, remove the front cover 4,
LED filter 9, key button F and switch board 5.
7) Remove the four screws K and remove the LCD module 8.