Sharp MD-MT15

22 wren the recording is complete, remove
the newly recorded MiniDisc and load
the master MiniDis into the MO-MT 16.
1©.00 not mistake the master MiniDisc
for the newly recorded MiniDisc.
3 wn
but
the stop mode, press the EDIT
fo solect ‘NAME STAMP”
4 Press the ENTER/SYNC button.
© To cancel the operation, press the
OFF bution,
S 4
|NAME STAM) | READ Ok?
5 ross the ENTERISYNC button
€@ The character information ofthe ma:
iniDisc is boing read.
6 won tho unit displays “CHANGE MO",
remove tho mastor MiniDisc
(@Faemove tho master MiniDise without
turing off the power I you do the
‘operation willbe canceled
5 6
| Readina! | {CHANGE MD |
T Load the newly recorded MiniDisc into
the MO-MTI5.
© To cancol the operation, pross the
OFF button.
[INSERT MD_|
ov
| TOC READ
0
(WRITE OK? |
3t
8 Press the ENTERISYNC button.
{© The unit wilinish recording the char-
‘acter information and enter the stop
ter MiniDisc does not match the total
‘aumber of racks on the newly recorded
MiniDisc, the unit will display “Can't
WRITE” and the power willbe tumed of
this happens, adjust the total number
cof tracks on the newly recorded MiniDisc
Using the edit operation, and then try
‘again from step 2.
CONV
‘Checking the remaining amount
NIENT OPERATION OF THE UNIT
1 To prevent the unit from being
‘of battery level
‘The remaining amount of battery level is
shown by the Battery indicator ( ===) dur-
ing operation.
[fila
< How to read the batty ncator >
wren e batory
ies Wevelaveryion”
h f
== =5 55>
‘Since the battery levels very ow, you
Cannot start recording or editing.
‘© When the battery is completely dis-
charged, the battery indicator will fash,
Recharge the battery or replace the al
kaline batteries with new ones.
‘© When the battery has run completely out,
“BATT EMPTY" will appear. Then, the
‘power willbe disconnected automaticaly.
Notes:
‘© When using the unit with alkaline bat-
teries ora rechargeable battery, the bat-
tery indicator will not correctly display
the remaining capacity for approximately
10 seconds after the power has been
turned on.
‘© When an AC adaptor or a car adaptors
used, the battery indicator will not be
‘shown.
‘© The number of bars shown in the bat-
tery indicator may increase or decrease,
‘depending on the operation being per-
formed. This is normal.
‘operated by mistake
To avoid accidental operation of the unit,
Use the hold function.
‘Move the HOLD switch to the safety posi-
tion (direction indicated by the arrow).
© When the untisin the bold mode, press:
ing the buttons wil have no affect.
© To cancel the hold mode, move the
HOLD switch away from the safety po-
sion (the oppostie drecton ofthe
row
tthe hold function is active while the power
‘is tured off, the power cannot be turned
on by mistake andthe battery wil not be
tally drained.