Sharp MD-MT15

To eliminate the confirmation
jound
Every time a button is pressed, a “beep”
willbe heard in the headphones.
‘To silence the “beep” sound, do the folow-
ing:
1 wnite in tne stop mode ..
Hold down the MODE button unt “SET
UP* appears.
‘© when you release the button, “BEEP
ON wil appear.
|__SET_UP _|s>|_BEEP ON |
2 Pross the MODE button
| BEEP OFF |
(© "BEEP OFF" will appear, and the con-
imation sound will disappear.
{@ To restore the confirmation sound, se-
lect "BEEP ON’.
3 Press the m:OFF button
‘© The normal display wil reappear
To cancel the auto-play function
‘When a MiniDiscis inserted, the power will
be tuned on automatically, and playback
will begin. You can cancel automatic play-
back.
1 nite in te stop mode ..
Hold down the MODE bution until “SET
UP" appears.
(© When you release the bution, “BEEP
‘ON" or BEEP OFF will appear
BEEP ON |
L SETUP I> peep OFF
2 ress the tee oF PPA button until “A-
PLAY ON? appears,
(@°A:PLAY OFF” will appear, and the
auto-play function will be canceled.
(© To restore the auto-play function, se-
lect “A-PLAY ON".
4 ress tne m:OFF button.
© The normal display wil reappear,
To cancel the auto power save
neon,
Power consumption can be reduced by
controling the memory storage time. You
‘can cancel the auto power save function
1 wnite in the stop mode ..
Hold down the MODE button until "SET
UP" appears.
‘© When you release the button, “BEEP
(ON or BEEP OFF" will appear,
| BEEP ON_|
SET UP_ | BEEP OFF |
2 Pressinetedormpibution untl"AUTO
save" appears.
(Psave OFF
(© “Psave OFF" wil appear, and the auto
Power save function willbe canceled.
(© To restore the auto power save func-
tion, select “AUTO Psave"
4 Press the MOF button.
(© The normal display will reappear.
‘About the sound skip guard memory:
‘During playback, approximately 10 seconds
Of information is stored in the semiconduc-
tor memory. Therefore, even when the
pickup cannot read information fora second
‘or two due to an external shock, the sound
vill continue without interruption because the
information stored in memory is used.
‘About the auto power save function:
This isa function used to save power when,
using the unit with the rechargeable bat-
tery or the alkaline batteries. While in the
‘auto power save mode, 5 - 10 seconds of
‘sound information is stored in memory.
‘When the auto power save function is dis~
abled, 10 seconds of sound information is.
‘always stored in memory. (When the AC
‘adaptor or a car adaptor is used, the infor-
‘mation storage time is always 10 seconds,
regardless of the auto power save mode.
‘When the units used in places exposed to
‘excessive vibration, cancel the aulo power
‘save function.