Sharp MD-MT15

USING WITH OTHER EQUIPMENT
© Beloreconecing any herequement, ml Listening through a stereo or 2
lum off the power to all units. Sanaa Een
© Connect the plugs securely. oe
Improper connections may causenoise Na cassette tape
‘or malfunctions.
istening
througt
‘To
the
line
input
jacks
= Tote right (A
Cel
I=
=~
Tomelen v.
We
Separatly available
‘cassette adaptor
(aD-cr14) ©
\
Tothe 0 jack
(© The separately available cassette adap-
tor may not work, depending on your
car's stereo.
HAT IS A MINIDISC?
A MiniDisc isa disc inside a protective car-
tridge. You can handle it freely without wor-
"ying about dust, fingerprints, etc.
However, if dust enters the opening of the
cartridge, or there is excessive dir on the
cartridge, orthe cartridge becomes warped,
you may experience malfunctions.
Piease note the folowing,
Handling the MiniDisc
Do not touch the disc directly!
Do not open the shutter or touch the disc
ciety.
ithe shutter is opened forcibly, it may break
|
|
© ‘The recording will be made in the ana
log mode.
(© When you want to listen to a disc using
2 separate stereo system or radio cas-
sette player, itis recommended that you
‘adjust the volume on the MiniDisc unit
to maximum,
© ‘Never disassemble a MiniDisc
1 Where not to store discs
Do not store discs in places with high tem-
eratures or humidity. Specifically, do not
leave discs in places exposed to direc sun-
light or in cars withthe doors and windows
closed.
Do not leave discs in places where sand
can get into the cartridge easily (e.9.,
beaches)
i Helpful tip when attaching a label
When attaching a label to an MO cartridge,
be sure to note the following. Ifthe label is
‘ot attached propery, the MiniDisc may jam
inside the unt and it may not be possible to
remove it.
© tite label peo ottor
Seneca
» Sater
:
‘area, it may cause the disc to jamin the
unit)
Regular cleaning
If the surface of the cartridge becomes
dusty or diy, clean it with a dry cloth.
TROUBLESHOOTIN
Moisture condensation
In the following cases, condensation
may form inside the unit.
© Shorty after turing on a heater.
When the unitis placed in a room where
there is excessive steam or moisture.
© When the unit is moved from a cool
place to a warm place.
When the unit has condensation inside,
the disc signals cannot be read, and the
unit may not function properly.
© If this happens, remove the disc.
‘The condensation should evaporate in
‘approximately 1 hour. The unit will then
function property