Sharp MD-MT15

RECORDING FI
THE
lm Recording from the microphone
(Mic synchro recording)
The recording will begin automaticaly in
response to a noise or a person speaking,
When the sound stops, the recording will
pause. This function is convenient when
ecording lectures, conferences, etc.
ICROPHONE
'3 Press the REC button.
‘© A monaural, long play recording mode
is availabe. (Page 17)
(© Timed identification marks can be cre-
‘ated
while
recording.
(Page
15)
4
Press
the
tea
oF
Pi
button
to
adjust
the recording level.
‘Stereo microphon
(commercially available)
1 Connect the stereo microphone to the
MIC IN jack,
{@ When a microphone is connected to
this unit, the unit wil automatically
switch to input from the microphone.
2 insert a recordable MiniDise.
(See page 10.)
13
Tho
i]
oT?
MIC"
Lia,
{© Adjust the recording level so that the
‘maximum sound volume from the
‘Source makes the reading swing be-
tween ~4 dB and 0 48.
‘© When the recording level display is
‘changed from "MIC H 21" to "MIC L
207, the sound willbe interrupted mo-
'5 Press the ENTER/SYNC bution to se-
lect the synchro recording level. (This
level can be changed, even while re-
cording.)
(© eter to the following table.
‘© When the microphone input is set to
"MIC SYNC H”, recording will start
when the lowest noise is detected. If
the unit starts recording too often trom
small unwanted noises, set the micro-
Phone input to “MIC SYNC L”
6 wnena sound, such as aperson speak-
ing, is picked up by the microphone, re-
‘cording will begin automatically.
‘© a silence lasts for 3 seconds or
‘mare, the recording willbe paused au-
‘omatically. However, the unit wil not
‘pause for about the frst 10 seconds
‘after recording has started.
To interrupt a synchro recording:
Press the PM button while recording,
{© The Mic synchro recording mode willbe
‘canceled, and the unit will enter the re-
cording stand-by mode.
{© Toresume synchro recording, press the
ENTERVSYNC button again.
To stop recording:
Press the MV:OFF button,
1§ Recording from the microphone
(ile manual recording)
‘You can start recording manually (anytime
you like)
1 Pus the unit in the recording stand-by
mode. (Perform steps 1 - 4in the “Mic
‘synchro recording” section.)
2 Press the mm button,
© Recording wil star.
To interrupt a recording:
Press the eat bution while recording.
(© ‘The unit wil enter the recording stand-
by mode.
{© Toresume recording, press the eM but-
ton again.
The track number wil be increased by
‘one each time you interupt a record-
ing
To stop recording:
Press the lW:OFF button.
4
Notes:
Myouwantto use a microphone, be sure
itis a plugcin-power type microphone.
‘@ When a plug-in-power type micro-
‘phone is pluggedin, the main unit wil
provide power for the microphone's
‘operation.
‘© Ifa different type of microphone is
plugged
in,
it
may
not
operate
prop-
ery
or
it
may
cause
the
unit
to
mal=
function
© ‘Insert the plug firmly. f you don't, the
recording will nt be made properly.
‘© Use a microphone with a 1/8" (3.5 mm)
diameter stereo mini plug,
'@ While making a mic recording, do not
‘connect anything to the OPTICAL/LINE
IN Jack on the main unit.