Sharp MX 3070

44
Fax
BROADCAST TRANSMISSION DOES NOT WORK
Check Solution
Has broadcast setting been disabled
in the setting mode (administrator)?
■ Broadcast transmission cannot be performed when "Setting mode
(administrator)" - [System Settings]
→ [Image Send Settings] → [Fax Settings]
→ [Send Setting] → [Disable Fax Broadcasting] is disabled.
THE FAX RECEPTION / DATA INDICATOR DOES
NOT TURN OFF
Check Solution
Did you retrieve a received fax that
was printed?
■ The fax reception / data indicator blinks until received faxes are retrieved.
Is an error preventing received faxes
from being printed?
■ The fax received / data indicator blinks when a received fax remains in memory
without being printed. Clear the error that is preventing printing.
I DON'T KNOW HOW TO CHECK AN ADDRESS
WHEN SENDING A FAX
Check Solution
Tap the [Address Review] key. ■ Tap the [Address Review] key to view a list of the addresses.
Is "Fax Dest. Confirmation Mode"
enabled in setting mode?
■ Enable "Setting mode (administrator)" - [System Settings] → [Image Send
Settings]
→ [Fax Settings] → [Default Settings] → [Fax Dest. Confirmation Mode].
When this setting is enabled, an address confirmation message will appear when
you send a fax to prevent erroneous transmission.
?
!
?
!
?
!