Sharp MX-3070N

SHARP
WIRELESS LAN SETUP
25
For MX-3070/3570/4070N series, two connection methods are available for Wireless LAN:-
Infrastructure Mode:
Infrastructure mode allows for wireless communication between two client devices via a host (access point).
The MFP connects to an access point to obtain an IP address.
Simultaneous usage of Infrastructure mode and wired connection is prohibited.
Access Point Mode:
Access Point (Ad-Hoc) mode allows for direct wireless communication between two client devices. Wireless
devices acquire an IP address from the MFP directly, allowing Print/Scan features to be available from mobile
devices.
Simultaneous usage of Access Point mode and wired connection is allowed however, mobile devices will not
be able to connect to the intranet/internet when connected to the MFP Wireless LAN.
Wireless LAN Support:
For Wireless LAN specification information, please refer to the Machine Specification section [Wireless LAN]
within this guide.
Wireless LAN Supported Connections:
Type
Wired LAN
Wireless LAN
Infrastructure Mode
Wireless LAN
Access Point Mode
Description
1

X
X
Connections are only available using the
conventional wired LAN connection.
2
X

X
Connections are only available using
Infrastructure Mode [Wireless LAN].
3

X

Connections are available either using wired
LAN or Access Point Mode [Wireless LAN].
When only Access Point Mode is required
and no wired LAN is used, please select this
connection type.
MFP Functionality - Access Point Mode:
Viewing of the MFP webpage (HTTP/HTTPS).
Printing (LPD / Raw / IPP / IPP-SSL / FTP push).
Scanning (Scan to FTP / SMB).
Remote Operation Panel.
Access to the SMB server.
mDNS communication.