When using Sharp Print Release, what
is the recommended number of client
MFPs that can be connected to the
MFP Master?
It is recommended that up to 5 client MFPs can be
connected to a single MFP master.
Within Job Status display, is it possible
to view Estimate Job Start Time?
To enable this function, change
SIM55-03 SW35-1 from 0 (default) to 1.
Is it possible to Tandem
MX-3070/3570/4070N series with
another MX colour device?
Tandem operation is only supported with
MX-3070/3570/4070N series only.
Is it possible to retain the Destination
Address (Image Send Mode), once the
current Scan operation is complete?
To enable this function, change
SIM55-03 SW30-3 from 0 (default) to 1.
Once enabled, go to System Settings-Image Send
Settings-Common Settings menu and enable the “Hold
Address for a while after scanning is completed” option
for the relevant Image Send mode.
What is the part code for the optional
RS232 Connector PWB Unit that
attaches to the SCN-MFP PWB?
Unable to print via USB Host Port
As default, the USB Host port is disabled.
Enable using SIM26-50 – Item I
Unable to perform scanner (CCD)
colour balance & gamma adjustment
using SIM63-3.
For MX-3070/3570/4070N series, SIT Chart
UKOG-0280FCZZ that was used for the previous model
series is not compatible – use UKOG-0356FCZZ
After upgrading from Windows 8 to
8.1 / 10 or Server 2012 to 2012R2,
“Features” information on the printer
properties is not displayed.
This is caused by the OS upgrade.
If you change the Printer Name or change/reset the Port
properties of the queue, the Features information will
return.
Using PC-Fax Preview function on
Windows 8.1, 10 or Server 2012R2,
the preview image and sending result
is incorrect
When using PC-Fax driver on Windows 8.1, 10 or
Server 2012R2, set the FAX resolution setting to
200x200dpi, 400x400dpi or 600x600dpi.
How to setup scan to Office 365 email
from the Sharp MFP?
Check the following settings under System Settings ->
Network Settings -> Service Settings -> SMTP:-
Primary Server: smtp.office365.com
Port Number: 587
Sender Address: ****@onmicrosoft.com
SSL: ON
SMTP Authentication: ON
To Next Page
Loading...
