MX3500N SCANNER SECTION C – 7
4. Maintenance
A. Optical Section
When moving the copy lamp unit manually for cleaning or adjusting the scanner section and the mirror section, be sure to turn OFF the main
power source (the power switch inside the front cover) and confirm that the power LED on the operation panel is OFF.
If the copy lamp unit is manually moved with the main power ON, the trouble code "F6-30" may occur.
If the trouble code "F6-30" is not canceled by turning OFF/ON the main power, refer to the Service Manual (FAX self diagnostics and the trou-
ble codes).
: Check (Clean, replace, or adjust according to necessity.) {: Clean : Replace : Adjust ✩: Lubricate : Shift the position.
No. Part name
Monochrome
supply/
Mechanical
parts
When
calling
150
K
300
K
450
K
600
K
750
K
900
K
1050
K
1200
K
1350
K
1500
K
1650
K
1800
K
Remark/Refer to the
Parts Guide.
Block/Item No.
(Only the replacement
parts are described.)
1 Mirror/Lens/
Reflector/CCD
Mechanical
parts
{ {{{{{{ { { { { { {
2 Table glass/
SPF glass
{ {{{{{{ { { { { { {
3 Scanner lamp { {{{{{{ { { { { { {
4 Rails ✩ ✩✩✩✩✩✩ ✩ ✩ ✩ ✩ ✩ ✩Specified positions
5 Drive belt/
Drive wire
4
2
4
2
4
3
5
5
1
1
1
4
To Next Page
Loading...
