Sharp MX-M3071 Troubleshooting

16
General Problems
THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN
Check Solution
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
■ This may improve some states of paper curling.
► Placing the original and adding paper
(page 5)
THE IMAGE IS SKEWED ON THE PAPER
Check Solution
Is too much paper loaded into the
bypass tray?
■ Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line.
The maximum number of sheets varies depending on the paper type setting.
Are the bypass tray guides adjusted
to the width of the paper?
■ Adjust the bypass tray guides to the width of the paper so that they slightly
contact the sides of the paper.
Are the original guides adjusted to the
width of the paper?
■ Adjust the original guides to the width of the paper.
Are you scanning originals of mixed
width? (In a reversing single pass
feeder (RSPF))
■ If the printed image is skewed when you have scanned originals of mixed width,
open the document feeder cover, change the switch position, and place the
originals.
The A position of the switch is for normal scanning. The B position is for scanning
of mixed originals.
Be sure to set the switch back to the A position after the mixed original job is
finished.
?
!
?
!
B
A

Sharp MX-M3071 Specifications

General

Print Technology	Laser
Print Speed	30 ppm
Print Resolution	1200 x 1200 dpi
Copy Speed	30 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Functions	Print, Copy, Scan, Fax
Max Paper Size	A3
Duplex Printing	Yes
Monthly Duty Cycle	100, 000 pages
Automatic Document Feeder	Yes
Connectivity	USB, Ethernet
Memory	5 GB
Hard Disk Drive	500 GB
Operating System Compatibility	Windows, Mac, Linux
Fax Resolution	Up to 400 x 400 dpi
Paper Capacity	Standard: 650 sheets (550-sheet tray + 100-sheet bypass tray); Maximum: 6, 300 sheets