Sharp NU-JC410

SIM02E-011
5
Annex
(normative)
【Test load】 【Design load】
Table.A1-1 Test load using clamps on long frames (see Fig. A1)
Table.A1 Design load using clamps on long frames (see Fig. A1)
clamp center position
clamp center position
(e: mm)
downward force
upward force
(e: mm)
downward force
upward force
234 ＜ e ＜326
5,400Pa
2,400Pa
234 ＜ e ＜326
3,600Pa
1,600Pa
0 ＜ e ＜430
2,400Pa
2,400Pa
0 ＜ e ＜430
1,600Pa
1,600Pa
Table.A2-1 Test load using clamps on short frames (see Fig. A2)
Table.A2 Design load using clamps on short frames (see Fig. A2)
clamp center position
clamp center position
(e: mm)
downward force
upward force
(e: mm)
downward force
upward force
0＜ e ＜255
1,800Pa*
1,800Pa*
0＜ e ＜255
1,200Pa
1,200Pa
Table.A3-1 Test load using clamps on long & short frames (see Fig. A3)
Table.A3 Design load using clamps on long & short frames (see Fig. A3)
clamp center position
clamp center position
(L, S: mm)
downward force
upward force
(L, S: mm)
downward force
upward force
0＜ L ＜430 , 0＜ S ＜255
1,800Pa*
1,800Pa*
0＜ L ＜430 , 0＜ S ＜255
1,200Pa
1,200Pa
Table.B-1 Test load using Bolt Holes (see Fig. B,B1)
Table.B Design load using Bolt Holes (see Fig. B,B1)
bolts & nuts
bolts & nuts
(position of using holes)
downward force
upward force
(position of using holes)
downward force
upward force
4points at "a" holes
5,400Pa
2,400Pa
4points at "a" holes
3,600Pa
1,600Pa
The Test load has been calculated with a safety factor of 1.5 from the design load.
* Test procedure according to IEC 61215-2:2016. The test results are based on internal evaluation.
design load
test load according to IEC61215
design load according to
design load according to IEC61215
design load
test load according to IEC61215
test load according to IEC61215
design load according to IEC61215
e
e
1. Spring washer 2. Washer
Material: Stainless steel Material: Stainless steel
Diameter: M8 8.2/15.4mm Diameter: M8 8.5/15.5mm
Thickness: 2 mm (reference value) Thickness: 1.6 mm (reference value)
3. Bolt 4. Nut
Material: Stainless steel Material: Stainless steel
Size: M8 Size: M8
Diameter: M8 x 20mm
Fig.
B
1
: The components for BOLT & NUT