Sharp PN-CD701 Supplemental Information

5. Notes on updating firmware
13
5-2. USB Flash Drive
*1
*1 If the FW update is performed in this way, the setting value will be cleared, so reconfiguration is required.
You can update using a USB flash drive. Please perform the following procedure.
1.Please start your computer and Download the “PN-CD701” Zip file from
the SHARP Information Display Downloader
*2
.
2.Unzip the downloaded file and save the “FWU_Config” file and “WCD70” directory
to the USB memory directly under the root.
Figure. SHARP Information Display Downloader
3. “Insert the USB flash drive into the USB terminal of “FOR CAM” next to the Service port.”
4. Please tap “Update” of "USB Firmware Updates" in the Admin menu.
After scanning the file, Please tap “Continue”.
*3 Do not let go of the buttons until the “Egg” picture appears on the screen.
Figure. Egg picture
5. Wait for the update to complete. (Approximately 10 minutes)
Do not turn off the power until the OOBE is displayed as it may cause a malfunction.
*2 If you do not have the tool, please contact an authorized SHARP servicing dealer or service center.
Figure. Update procedure

Sharp PN-CD701 Specifications

General

Response time	6 ms
Display diagonal	70 \
Display brightness	350 cd/m²
Display technology	LCD
Native aspect ratio	16:9
Contrast ratio (typical)	4000:1
Display number of colors	1.06 billion colors
Display diagonal (metric)	176.6 cm
Viewing angle, horizontal	176 °
Number of simultaneous touchpoints	10
RMS rated power	24 W
Number of built-in speakers	2
Wi-Fi	-
USB version	2.0/3.2 Gen 1 (3.1 Gen 1)
USB ports quantity	5
Windows operating systems supported	Windows 10
AC input voltage	100-240 V
Heat dissipation	801 BTU/h
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	370 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	CE, CB
Sustainability certificates	RoHS
Orientation	Horizontal/Vertical
Product color	Black
Product design	Digital signage flat panel
Bezel width (side)	41 mm
Placement supported	Indoor
Bezel width (bottom)	53 mm
Panel mounting interface	400 x 400 mm
Purpose	Corporate
Harmonized System (HS) code	85285210

Weight and Dimensions

Depth	90 mm
Width	1623 mm
Height	976.4 mm
Weight	65000 g