Sharp PW-E310 - Page 54

E-4
Turning the power on/off
The power can be switched on by pressing the keys listed below.
To turn off the power, press
o .
Key
o
m
t
u
t
a
k
Display status upon start-up
Restores the display as it was before the unit was switched off
(Resume function).
The main menu screen appears.
The main display of each dictionary and/or function appears (Direct-
on function).
Auto power off function
To save the battery, the PW-E310 will automatically turn its power off if no key
operations are detected for a set period of time. The activation interval initial setting
is 5 minutes, but it can be adjusted by following the directions on page E-12.
Key notation used in this manual
• All keys are framed ( A , for instance); exceptions are found in the Calculator
section, where the numeral entries are shown with real numbers.
•Keys are often assigned with more than one function. The appropriate key/
function will be shown according to the input status.
<Example 1>
will be shown as either ‘ Q ’, ‘ 1 ’ or ‘1’ depending on the input status.
<Example 2>
will be shown as either ‘ G ’ or ‘ + ’ depending on the input status.
• The functions indicated with green typeface are second functions. Press and
release
^ , then press an appropriate key.
<Example 1>
^ ? directs to press and release ^ , then press ? ( M ).
^ w directs to press and release ^ , then press w ( < ).
To attach a commercially available strap
A carrying strap can be attached, as shown in the picture below.
Caution:
• Do not swing the unit by the strap, or use excessive
force to pull the strap. Doing so will cause a
malfunction or hardware damage to the unit.
Back of the unit