57 | Page
• Be careful not to let the tape protrude from the edge or
surface of the card. If the tape is jutting out, the card
operation will not be smooth, or the tape will peel off.
• In addition, please wipe the any dirt and etc. off the card
before applying the protection tape.
REC AUT / DEF modes. Used for recording cards. Load program
in PRO mode. Once program is loaded, switch to AUT / DEF
mode, press REC and observe flashing BUSY then CARD
prompt. Insert card and observe flashing CARD prompt.
Pull card and insert side two if prompted with a solid CARD
prompt. Continue with new card if prompted again with
new solid CARD prompt. There is a time limit for insertion
and pulling the card.
To Next Page
Loading...
